Cetop 5 - 12vdc Double Solenoid Valve ADP5E.01.C.L.00.1

Cetop 5 / NG10 High Performance Directional Control Valve

Double solenoid valve - spool type 01

Double solenoid valve 12vdc

ADP5E.01.C.L.00.1

The ARON NG10 directional control valves are designed for subplate mounting with an interface in accordance with UNI ISO 4401 - 05 - 04 - 0 - 94 standard (ex CETOP R 35 H 4.2-4-05). The use of solenoids with wet armatures allows an extremely safe construction completely dispensing with the need for dynamic seal. The solenoid tube is screwed directly onto the valve casing whilst the coil is kept in position by a ring nut. Great care has been taken over the design and production of the ducts and the improvement of the spools allows relatively high flow rates to be accommodated for its size with minimal pressure drops (Δp). The operation of the directional valve is electrical. The centring is achieved by means of calibrated length springs which, once the impulse is over, immediately reposition the spool in the neutral position. The solenoids, constructed with a protection class of IP66 in accordance with BS 5490 standards, are available in direct current form and different voltage. The electrical controls are equipped with an emergency manual control inserted in the tube. The ADP.5.E.. valve has certain design features which allow it to 'manage' a hydraulic power equal to Q = 120l/min with a P = 320 bar, maintaining a considerable safety margin. These features can be summarized as follows:

• Solenoid D19 with an optimum ratio between the power absorbed (42W) and the magnetic force
• Diameter of the spool 18 mm, with carefully designed geometry improved to compensate for the flow forces
• Compact graphite cast iron valve casing with high mechanical resistance
• Different springs, improved according to the features of the spool The electrical supply connectors meet DIN 43650 ISO 4400 standards; connectors are also available with built in rectifiers or pilot lights. The recommended fluids are hydraulic mineral based oils in accordance with DIN 51524 and it is recommended that filters should be fitted to ensure a maximum contamination level of class 10 in accordance with NAS 1638, β₂₅≤75.

For other fluids please contact our Technical DPT.
The solenoids are in DC voltage only.

Click here for technical information (pdf)